AliBubba
Senior Member
I have a Jack Scott Cutter box-call that I had to replace the screw. Looking for ideas how to properly tune it?
Welcome Guest!
How to tune a box call?
- Thread starter AliBubba
- Start date
BOB_HARWELL
Senior Member
Send it back to Jack & let him do it.
Bob
Bob
grouperdawg
Senior Member
You shouldn't have to do much to tune it, just hand tighten the screw until you get the sound you like. It will probably get higher pitched once you get past level
You may need a little chalk
Call makers use a knife or sometimes sand paper to fine tune a box but It should have already been tuned. It's more complicated than it sounds and I wouldn't recommend unless you really know what you're doing.
You may need a little chalk
Call makers use a knife or sometimes sand paper to fine tune a box but It should have already been tuned. It's more complicated than it sounds and I wouldn't recommend unless you really know what you're doing.
Similar threads
