Welcome Guest!
New Belt Grinder
- Thread starter dawgwatch
- Start date
SemperFiDawg
Political Forum Arbiter of Truth (And Lies Too)
Welds look better than mine.
dawgwatch
Senior Member
I'm not a welder by any means...lol
rayjay
Senior Member
rayjay
Senior Member
I've been very happy with the plastic wheels on my grinder. You will know pretty quickly if you don't have enough spring.
On the OP's grinder it would be interesting to see if you could come up with some flat shims of plastic or wood to place in the sliding tension section of the machine. This would tighten up the tolerances of the sliding portion.
On the OP's grinder it would be interesting to see if you could come up with some flat shims of plastic or wood to place in the sliding tension section of the machine. This would tighten up the tolerances of the sliding portion.
T-N-T
Senior Member
Looking good cuz!
You get a whole shop full of knife building tools together and I might have to drop in on you....
You get a whole shop full of knife building tools together and I might have to drop in on you....
dawgwatch
Senior Member
The shims are a definite need that will hopefully be in place in the next week....
And Cuz as far as the shop full of knife building tools....Its full now.... mostly because of the size of the shop and not the massive assortment of tools...lol
And Cuz as far as the shop full of knife building tools....Its full now.... mostly because of the size of the shop and not the massive assortment of tools...lol
Similar threads
