Welcome Guest!
Clutch stuck to pressure plate ???
- Thread starter BDD
- Start date
OmenHonkey
I Want Fancy Words TOO !
Crank it by pushing/pulling it off. then drive the stew out of it. The heat should break it loose. Never seen one stick after sitting only for 1 week. You could have bigger issues.
NE GA Pappy
Mr. Pappy
Get someone to pull it, put it a higher gear... 3rd or 4th and when you get to about 10 or 15mph, dump the clutch. If it is just stuck from sitting that should break it loose.
Or course, it could be the hydraulic clutch slave or master has gone bad and leaked down, in which case, all the above will be a waste of time. I would probably get someone to push in the clutch pedal while I was under the truck to verify that the clutch is being disengaged. Make sure you scotch the wheels before you get under it.
Or course, it could be the hydraulic clutch slave or master has gone bad and leaked down, in which case, all the above will be a waste of time. I would probably get someone to push in the clutch pedal while I was under the truck to verify that the clutch is being disengaged. Make sure you scotch the wheels before you get under it.
naildrvr
Senior Member
Used to have an old truck that would stick like that. I would crank it up and let it pull itself and stomp the brakes hard. That would always free it up.
