cramer
Senior Member
Cranks and runs fine , but won't go forward or reverse or PTO engage.
Any ideas?
Any ideas?
Welcome Guest!
John Deere 5055E won't go forward or reverse
- Thread starter cramer
- Start date
NOYDB
BANNED
Shear pin need to be replaced?
rospaw
Senior Member
Not sure if it has High / Low trans but if it does, did it get bumped between the two?
Clutch usually doesn't go out parked. Was it driving fine before being parked? Is it a wet system where the fluid could have leak out causing no fluid/no drive?
Clutch usually doesn't go out parked. Was it driving fine before being parked? Is it a wet system where the fluid could have leak out causing no fluid/no drive?
cramer
Senior Member
Thanks for replying guys - It's a buddy's tractor so I don't know the answers.
I will get him to check this forum and see if he can reply.
It is a new to him tractor , so hopefully he knows. <40 hrs
It was running fine, bush hogging last weekend and then stopped moving.
We were down at the club looking at it this evening and I did not have access to the site. checking for loose connections and hoping for a miracle.
If you want answers - this is the place to go
I will get him to check this forum and see if he can reply.
It is a new to him tractor , so hopefully he knows. <40 hrs
It was running fine, bush hogging last weekend and then stopped moving.
We were down at the club looking at it this evening and I did not have access to the site. checking for loose connections and hoping for a miracle.
If you want answers - this is the place to go
Lilly001
Senior Member
Fuse block at your feet in the operators platform. Uses those realy small fuses. I think 20 amp, and there are two of them.
Ask me how I know.
If that doesn't work call the dealer. That's how I do it.
Ask me how I know.
If that doesn't work call the dealer. That's how I do it.
Similar threads
