Go Back   Georgia Outdoor News Forum > Firearms > Gunsmithing Discussion and Tips


Reply
 
Thread Tools Display Modes
  #1  
Old 02-03-2018, 07:58 PM
deerpoacher1970 deerpoacher1970 is offline
Join Date: Oct 2016
Location: alabama
iTrader: (0) Check/Add Feedback
Default Savage A22 WMR

Just purchased a new Savage A22 WMR and will not shoot Winchester ammo looks to me like firing pin is not hitting hard enough I have heard that winchester case's are harder anyone have any experience with this.
Reply With Quote
  #2  
Old 02-03-2018, 10:17 PM
Yotedawg's Avatar
Yotedawg Yotedawg is offline
Join Date: Apr 2009
Location: Cairo
iTrader: (0) Check/Add Feedback
Default

Shouldn't matter about the ammo casing being harder. The gun should hit it hard enough for ignition. If it's a new gun as you stated, I would take it back to the store you purchased from and let them make it good.
__________________
Hunting the hunters.
Reply With Quote
  #3  
Old 02-04-2018, 02:01 PM
Hillbilly stalker's Avatar
Hillbilly stalker Hillbilly stalker is offline
Join Date: Aug 2016
Location: Piedmont Sc
iTrader: (0) Check/Add Feedback
Default

Clean it good. Packing grease or too much lube acts like a hydraulic. Does it shoot other brands alright ?
__________________

Georgia Mules and country boys are fading fast away
Reply With Quote
  #4  
Old 02-04-2018, 07:31 PM
deerpoacher1970 deerpoacher1970 is offline
Join Date: Oct 2016
Location: alabama
iTrader: (0) Check/Add Feedback
Default

Quote:
Originally Posted by Hillbilly stalker View Post
Clean it good. Packing grease or too much lube acts like a hydraulic. Does it shoot other brands alright ?
Yes it shoots CCI great no problems.
Reply With Quote
  #5  
Old 02-05-2018, 05:49 PM
Hillbilly stalker's Avatar
Hillbilly stalker Hillbilly stalker is offline
Join Date: Aug 2016
Location: Piedmont Sc
iTrader: (0) Check/Add Feedback
Default

I have had a lot of trouble with Winchester white box. They swell so bad that I have to dig them out of my .22 rifle with a knife. Their white box shotgun shells also swell so bad they have to be dug out of my single shot. They have really lowered their quality control. I would try different shells before anything . Its not every brick....but enough that its a pain. My Ruger American Rimfire will not feed a lot of Remington shells for some reason, but will any other. Good luck.
__________________

Georgia Mules and country boys are fading fast away
Reply With Quote
  #6  
Old 02-06-2018, 12:16 PM
jmoser's Avatar
jmoser jmoser is offline
Join Date: Mar 2010
Location: MI
iTrader: (2) Check/Add Feedback
Default

Case dimensions and bullet profile can cause issues; Check 2 things:

1] bump the bolt closed with your hand after loading [like the fwd assist on an AR.] Some rounds go in just far enough so the gun will fire [in battery] but the pin just pushes the cartridge forward the last little bit.

2] load and eject an unfired round, see if it ejects easily and if you can see any marks on the bullet where it may be contacting the rifling. This can result in [1] above, the pin pushes the case forward robbing it of energy needed to pop the primer.

2(a)] With bolt open try hand loading a round, push in with a flexible coffee stirrer / popcicle stick etc. See if you can fully seat the rim without excess force. Then see if you can extract easily with a thin strip of plastic cut from a gift card or similar 'thinner than a credit card' piece. [Clear 'clamshell' packaging works well for this if not too thick.] Idea is to make sure the cartridge is fully seated and cannot move fwd when hit.

If none of these then try to measure rim thickness of good/bad ammo. This can vary.

It could be an issue with firing pin protrusion and/or headspace but if CCI / Remmy ammo works fine I suspect its something in that specific Win case/bullet.
__________________
Jeff
Reply With Quote
  #7  
Old 02-11-2018, 03:15 PM
deerpoacher1970 deerpoacher1970 is offline
Join Date: Oct 2016
Location: alabama
iTrader: (0) Check/Add Feedback
Default

Problem solved took rifle apart and cleaned good shot a full mag full without a hiccup.
Reply With Quote
  #8  
Old 02-12-2018, 11:24 AM
jmoser's Avatar
jmoser jmoser is offline
Join Date: Mar 2010
Location: MI
iTrader: (2) Check/Add Feedback
Default

Quote:
Originally Posted by deerpoacher1970 View Post
Problem solved took rifle apart and cleaned good shot a full mag full without a hiccup.
Funny how that fixes a lot of rimfires !!! They do sure gunk up semiautos.

Glad to hear.
__________________
Jeff
Reply With Quote
Reply


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On
Forum Jump


All times are GMT -4. The time now is 08:03 PM.


Powered by vBulletin® Version 3.7.4
Copyright ©2000 - 2018, Jelsoft Enterprises Ltd.
Copyright 2004 Georgia Outdoor News, Inc.Ad Management by RedTyger