chainsaw custom trigger?

K80Shooter

Senior Member
if a 2cycle is overheating, then it is either covered in dirt and trash, or the mixture is lean, or the fuel is not mixed correctly.

Check to make sure you have the fuel/oil mixed correctly. If you do, then you probably need to retune the carb so that enough fuel is flowing to lube and cool the engine correctly. Make sure all the baffles are on, clean and clear.

Speaking of the carb, I noticed in the owners manual it say's to run the screws in all the way and back them out 1-1/2 turns. Now reading the repair manual it say's to run them in all the way and back them out 1 turn. Anyone know why there's a discrepancy and which is right? Again both manuals are for the 009,010,011 saws.
 
Top