Bow tech troubleshooting

burkehunter

Senior Member
I'm just getting into working on my own bow. I changed my cables and string on an obsession bow. I can't seem to get my specs quite right. Specs are 32" ata, 6 in brace, and 65lbs. My ata is 5/16 out of spec. My brace height was about right. My draw weight was a few pounds low. I added equal twists to my cables and no change to ata even after around 4 twists. Added a couple twists to my string. Still no change to ata but now my poundage is several pounds low. Any advice? I think I'm missing something. I'm determined to get this figured out.
 

Ihunt

Senior Member
I’m no expert but I wouldn’t worry about 5/16”.
 

BamaGeorgialine

Senior Member
I’m no expert but I wouldn’t worry about 5/16”.
I agree. I started watching some YouTube videos and fell into the splitting hairs every shot mindset, when I was grouping arrows within an inch of each other. Nothing wrong with it, but it'll drive you crazy. If your form is wrong and your hitting your mark then make sure your form is wrong the exact same way every time and you're good to go
 
Top