Paper tuning

[ppdaazn]

First time trying this on the vertix i just got. Shooting through whisker biscuit rest. After tweaking around with the knocking point and rest I think this is good to shoot? Bottom 2 are last shots. Didnt do bare shaft tune yet

 

[Kris87]

Bottom two look good. Sling a bareshaft through it for the real story.

 

[ppdaazn]

Bottom two look good. Sling a bareshaft through it for the real story.

Will try soon! Hopefully bullet hole also

 

[ppdaazn]

The middle 3 holes i kinda torque my wrist a bit. The others i did kinda closed eyes so i dont torque. You think its close enough bullet hole?

 

[ppdaazn]

Another shot here

 

[ppdaazn]

Bottom two look good. Sling a bareshaft through it for the real story.

Quick question, i got a mathew vertix 28.5” draw and using the whisker biscuit. Full draw the arrow hangs off from the biscuit almost 3in. Arrow measured from insert to end of nock 29.75”. Is that arrow way too long?

 

[ddd-shooter]

Quick question, i got a mathew vertix 28.5” draw and using the whisker biscuit. Full draw the arrow hangs off from the biscuit almost 3in. Arrow measured from insert to end of nock 29.75”. Is that arrow way too long?

Flush with the front of the riser is pretty standard.

 

[Kris87]

Looking good. Just shoot your broadheads and make sure they're good at distance and call it a day.

 

[ppdaazn]

Looking good. Just shoot your broadheads and make sure they're good at distance and call it a day.

Will do. I shoot schwackers. Dont have fixed tip but will grab some later. Thanks!