2 wire jack plate diagram

Thread starter #1
hope this helps someone one day.
will work on tilt/motor also
added flex seal for protection

6$ea auto 5 pin relays 30 amp
you can use smaller wire to the switch.






pic with wire to motor unplugged.
 
Economical relay setup that would cost $$$ at a marine dealer ...

Pretty much work on any lower voltage DC motor that needs reversing directions ....
 

Lukikus2

Senior Member
Good stuff! You can swap them when one goes out to get by. Good engineering if you think about it. I dropped in Dale Hollow for a two day tournament when the down relay just quit. Err. 10 minutes before blastoff. A local mechanic supporting the Tx told me to swap the relays to get gone and had another waiting on me at weighin. Good people.
 
Top