Who loads for a Glock 34?

[Adam5]

Who else reloads for their G34?

I have a load that I’ve been using in GSSF for G17, that also shoots well in my Springfield SA35, Sig P239, and Shadow Systems MR920 w/Swampfox Liberty. It’s an Xtreme 124gr target hollow point over 3.7gr of TiteGroup with 1.06” OAL. I tried it in my G34 w/Holosun EPS, and it won’t cycle the slide at all. It doesn’t have quite about oomph to it.

I loaded some trial loads with a little heavier charge yesterday. I loaded Berry’s round nose over 7.5gr of Accurate #7, 6.5gr of HS6, and 4.4gr of W244 all at 1.09” OAL. They all ran flawlessly in it, as well as some 115gr Xtreme round nose over 4.6ge of W244 at 1.10” that I had on my shelf.

Who else loads for their G34? Any pet loads that you like to run?

 

[Dub]

Yes sir.....I'm planning on it.





I haven't worked up any loads for my G34 just yet.

Thus far my 9mm handloading has been coated lead tips over Sport Pistol.


I have some Montana Gold 124gr hollow points that I'll be loading for the G48 & G34 over Power Pistol, Unique, HP-38/W231 and TiteGroup.


Also have some Berry's plated 115gr round nose & Hornady fmj 115gr to experiment with.

 

[Ajohnson0587]

4.0gr VV-N320
124gr Precision Delta or Montana Gold JHP
Small Rifle Primer
1.100 COL

This is the load I use for every competition gun I own, Glocks, Sig, CZ, 1911’s, etc… All of them make 130-132pf for USPSA which is plenty for GSSF & IDPA. VV-N320 is a bit pricey, but it’s was cleaner than most powders, has a very consistent burn rate, and I also use it to load .40 cal