Can't find one i like, so build it

dwhee87

GON Political Forum Scientific Studies Poster
Been looking for a table to mount my Akorn in. Lots for BGE and other ceramics, but not for the workhorse...the Akorn. We'll see how it turns out. Best of all, most of the lumber was left over from my deck project.
20240518_101627.jpg

Top piece.

Bottom piece.
20240518_101610.jpg
 

1eyefishing

...just joking, seriously.
I think you'll need more 'joists' to frame in closer around the hole you're gonna cut into the top?
 

dwhee87

GON Political Forum Scientific Studies Poster
I'm leaving the brackets on where the side trays attach. Those will rest on the table top to suspend it.

Space between the two 'joists is 25 inches. Hole I'm about to cut is 22.5.
20240518_104354.jpg

Here goes nothin.
 

dwhee87

GON Political Forum Scientific Studies Poster

dwhee87

GON Political Forum Scientific Studies Poster
Wheels attached. A little adjusting on how it sits in the hole (dropped ears into cutouts supported by an extra 2x4), and she fits like a dream.
20240518_121204.jpg
 

dwhee87

GON Political Forum Scientific Studies Poster
I'll attach the bottom shelf once I get it up o to the deck. Less weight to carry, that way.
 
Last edited:
Top