I bought a piece of 3/4 aluminum angle at Lowes, bought a plastic cutting board at Walmart. Measured out the angle ehre I needed to make cuts at and cut a 90 degree notch in the bottom web of angle. Then bent it around the cutting board. Left it long enough on the long side that the angle would overlap an inch or so. Drilled a hole in it for a bolt, then tightened it down to a round driftmaster base. I left it just lose enough that when I didn't need it I could pivot it up. Worked great
Best I can come up with. Make sure it is fastened good, I didn't and it bounced off on lake lmboDo you have a picture?
I was planning to make one out of starboard to fit in a rod holder but it was going to be a $200 project.
ThanksBest I can come up with. Make sure it is fastened good, I didn't and it bounced off on lake lmbo
How big should I make the top?