B. White
Senior Member
Asking this in case anyone has done something similar. I am thinking about putting a utility sink in the corner of a pole barn that has insulated steel walls. It has no plumbing, but I can fill easily with a hose, since there is a spigot nearby. I would like to run PVC out into a barrel to use gray water for watering plants, etc. It wouldn't be used for anything except to wash collards or other vegetables instead bending over a wash tub and occasional use with a wringer washer for rinse and drain. I could go simple and put it outside, but would prefer to get it out of the sun for summer and cold and wind in cooler months.
My first concern is the guy who wired it wore out his hole saw bits and had to come back with new high dollar ones. Looking for any feedback on a good brand than can handle steel siding that may be harder than average.
The 2nd is whether to get fancy and use some type of bulkhead fitting going through the wall, or drill at a stud and secure the pvc to it and just caulk the gap.
My first concern is the guy who wired it wore out his hole saw bits and had to come back with new high dollar ones. Looking for any feedback on a good brand than can handle steel siding that may be harder than average.
The 2nd is whether to get fancy and use some type of bulkhead fitting going through the wall, or drill at a stud and secure the pvc to it and just caulk the gap.