Israel
BANNED
Meaning? If it is (as a I trust) and ECM x13 motor, swap out the control module on the motor? I'm game.Personally I would just plug in a new module for around 250 diy
Meaning? If it is (as a I trust) and ECM x13 motor, swap out the control module on the motor? I'm game.Personally I would just plug in a new module for around 250 diy
The term scarce as hen's teeth comes to mind as I been trying to hunt one up. At this point I am just about ready to travel to almost any point in Ga to get a 3/4 HP, ECM 2.3 (with one 16 pin one 5 pin connector) that rotates shaft end clockwise. If anyone has a line on one or where to look, any help is again, appreciated.You will need to get same module as original as modules are pre programed for motor rpms and horse Power rating
May be easier to get the whole motor. Not hard to install at all.The term scarce as hen's teeth comes to mind as I been trying to hunt one up. At this point I am just about ready to travel to almost any point in Ga to get a 3/4 HP, ECM 2.3 (with one 16 pin one 5 pin connector) that rotates shaft end clockwise. If anyone has a line on one or where to look, any help is again, appreciated.
Thanks for the encouragement...looks like I can get one for 600+, had hopes of getting away a bit cheaper (putting a 600+ motor on unit almost 20 y.o. causes me to balk) but then we just had a fellow give us an estimate on new equipment and looks like I'll be cobbing this old thing for a bit.May be easier to get the whole motor. Not hard to install at all.
Short of telling the whole tale...found an ECM 2.3 module (my fan had gone completely belly up, yet the motor itself "ohmed" out good) I put it on and got only one speed, slow, (at least working) but not enough to keep (what I am convinced) was high pressure cut off from tripping due to inadequate airflow over the evap coils to reduce head pressure.You need an Evergreen 6507V paired with a 5K010, hard to do all that under $600 though. Did you get this fixed?
I am reasonably convinced the matter is/was fixed with the new air handler circuit board that came last night and I replaced.You need an Evergreen 6507V paired with a 5K010, hard to do all that under $600 though. Did you get this fixed?